What to do if ARAG Data Loggers output pressure is sufficient but recording does not continue?
If, with sufficient output pressure, the ARAG Data Loggers recording does not continue and the PAUSE icon is displayed, it indicates that the digital input switching recording to PAUSE is active. Remove the active status of the external digital input.
Why ARAG Data Loggers air pressure sensor is connected, but the display does not show its value?
If the ARAG Data Loggers air pressure sensor is connected but the display doesn't show its value, it may be a programming error. Ensure that the air sensor is enabled in the proper menu (par. 11.2.1).
What to do if ARAG Data Loggers displays 'ERR. Ext. memory'?
If the ARAG Data Loggers displays 'ERR. Ext. memory', it indicates a possible device hardware problem. You can try one of these reset procedures: 1. Press OK for at least 2 seconds. 2. Press keys + OK for at least 2 seconds. This operation resets all parameters to the default values: the device must be set up again.
General| Refresh Rate | 60 Hz |
|---|---|
| Response Time | 5 ms |
| Brightness | 250 cd/m² |
| Contrast Ratio | 1000:1 |
| VESA Mount | 100 x 100 mm |
| Display | LED |
| Inputs | VGA |
To Next Page
