How to fix ARAG Measuring Instruments VISIO if it is off or does not switch on?
If your ARAG Measuring Instruments VISIO is off or not turning on, check the power cable connections to ensure a proper power supply. If the power supply is fine, make sure the device is turned ON by pressing the ON key.
What to do if my ARAG Measuring Instruments VISIO shows wrong data?
If your ARAG Measuring Instruments VISIO displays incorrect data, there might be a setup issue. Verify the displayed data setup. Alternatively, there could be a sensor fault; in this case, contact the nearest Assistance Center. A VISIO fault may also cause this issue.
What to do if my ARAG Monitor VISIO is off or does not switch on?
If the ARAG Monitor VISIO is off or doesn't switch on, there are a couple of things to check: * First, ensure that the device has power by checking the power supply connection. * Second, verify that the device is turned on by pressing the ON key.
Why does my ARAG Monitor VISIO show wrong data?
If your ARAG Monitor VISIO shows wrong data, it could be due to a few reasons. First, verify the displayed data setup to ensure it is correct. Another potential reason is a sensor fault.
How to troubleshoot filling pump not starting on my ARAG Monitor?
If the filling pump on your ARAG Monitor does not start, the pump stop module may not be powered. Check the power supply connection to resolve this.
What to do if ARAG Data Loggers displays 'Check sensor!'?
If the ARAG Data Loggers displays 'Check sensor!', it means recording is immediately interrupted because the sensor is either not properly connected or is damaged. Check the connections of the sensor corresponding to the alarm and the connection cable status. Also, verify the sensor's operation in Setup menu > Diagnostics > Sensors: the values must be between 3.5 mA and 20.5 mA for each sensor connected.
What to do if ARAG Data Loggers displays 'Too high pressure!'?
If the ARAG Data Loggers displays 'Too high pressure!', it indicates that the measured pressure exceeds the maximum value set in Setup menu > Alarms. Reduce the pressure to a correct value.
What to do if ARAG Data Loggers displays 'Too low pressure!'?
If the ARAG Data Loggers displays 'Too low pressure!', it means that the measured pressure is lower than the minimum value set in Setup menu > Alarms. Increase the pressure to a correct value.
Why ARAG Data Loggers display shows a wrong pressure value?
If the ARAG Data Loggers display shows a wrong pressure value, it may be due to a programming error where the connected pressure sensor doesn't match the programmed one. Correctly program the sensors in the proper menu (par. 11.1).
What to do if ARAG Data Loggers display does not switch on?
If the ARAG Data Loggers display does not switch on, it is likely due to no power supply. Check the power supply connection.
Guidance on optimal placement of the VISIO unit in the cabin.
Instructions for correctly connecting power supply and sensors to the device.
Setting minimum and maximum speed thresholds for alarm notifications.
Procedure to load a configuration file from a USB drive.
Lists common faults, their causes, and recommended remedies.
Provides detailed technical specifications for the VISIO device.
General| Refresh Rate | 60 Hz |
|---|---|
| Response Time | 5 ms |
| Brightness | 250 cd/m² |
| Contrast Ratio | 1000:1 |
| VESA Mount | 100 x 100 mm |
| Display | LED |
| Inputs | VGA |
To Next Page
