What to do if ARAG Data Loggers output pressure is sufficient but recording does not continue?
If, with sufficient output pressure, the ARAG Data Loggers recording does not continue and the PAUSE icon is displayed, it indicates that the digital input switching recording to PAUSE is active. Remove the active status of the external digital input.
Why ARAG Data Loggers air pressure sensor is connected, but the display does not show its value?
If the ARAG Data Loggers air pressure sensor is connected but the display doesn't show its value, it may be a programming error. Ensure that the air sensor is enabled in the proper menu (par. 11.2.1).
What to do if ARAG Data Loggers displays 'ERR. Ext. memory'?
If the ARAG Data Loggers displays 'ERR. Ext. memory', it indicates a possible device hardware problem. You can try one of these reset procedures: 1. Press OK for at least 2 seconds. 2. Press keys + OK for at least 2 seconds. This operation resets all parameters to the default values: the device must be set up again.
How to turn on ARAG Cash Counter VISIO?
If your ARAG Cash Counter VISIO is off or doesn't switch on, check the power cable connections to ensure there is a power supply. Also, make sure the device is turned ON by pressing the ON key.
Why does my ARAG Cash Counter VISIO show wrong data?
If your ARAG Cash Counter VISIO shows wrong data, first check the displayed data setup to ensure it's correct. If the issue persists, it might be due to a sensor fault, in which case you should contact the nearest Assistance Center.
What to do if filling pump of ARAG Cash Counter does not start?
If the filling pump on your ARAG Cash Counter doesn't start, check the power supply connection to the Pump Stop Module.
Guidance on optimal placement of the VISIO unit in the cabin.
Instructions for correctly connecting power supply and sensors to the device.
Setting minimum and maximum speed thresholds for alarm notifications.
Procedure to load a configuration file from a USB drive.
Lists common faults, their causes, and recommended remedies.
Provides detailed technical specifications for the VISIO device.
General| Refresh Rate | 60 Hz |
|---|---|
| Response Time | 5 ms |
| Brightness | 250 cd/m² |
| Contrast Ratio | 1000:1 |
| VESA Mount | 100 x 100 mm |
| Display | LED |
| Inputs | VGA |
To Next Page
