Need help?Do you have a question about the araknis AN-110-SW-C-5P and is the answer not in the manual?
Connect using 30W PoE+ input to enable full PoE OUT functionality.
Connect using 15W PoE input, which limits PoE OUT capabilities.
Details PoE output/input ports and power usage across different switch models.
Explains the Power LED status for system operational state (up/down).
Describes the 1Gbps LED for port speed indication (1Gbps vs 10/100Mbps).
Details the Link/Act LED for port connectivity and network traffic activity.
Guide to connecting the switch to the network and adding it to your OvrC account.
Instructions for performing a soft reboot by holding the reset button for 5 seconds.
Procedure for a hard reset to restore factory default settings via the reset button.
General| Model | AN-110-SW-C-5P |
|---|---|
| Ports | 5 |
| Port Speed | 10/100/1000 Mbps |
| Layer | 2 |
| Switching Capacity | 10 Gbps |
| Forwarding Rate | 7.44 Mpps |
| MAC Address Table | 2K |
| Power over Ethernet (PoE) | Yes |
| PoE Budget | 60W |
| Operating Humidity | 10% to 90% non-condensing |
| Mounting | Wall |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Managed | No |
To Next Page