The Aranet4 monitor has four small
configuration switches that allow the user to
adjust the settings.
To access the configuration switches, open
the cover of the battery compartment on the
back of the device. With the batteries
remaining inside, adjust the switch position
(up or down) using the pin tool supplied with
the Aranet4 device.
You can adjust the switches with the
batteries removed as well, but note that, if
you remove the batteries, it will erase the
measurement history from Aranet4
memory. To avoid this, update the data in
the Aranet4 app before removing the
batteries. The new settings will start working
once the batteries are back in.
Switch positions explained
4
Switch tool (PIN) can
be found in Aranet4
Quick Start Guide english
version.
Bluetooth – turn on or off the
Bluetooth (connection to
Aranet4 app).
Enable/disable the connection
to Aranet PRO base station
(available only for Aranet4 PRO
device). Refer to the chapter
“Using Aranet4 device with
the Aranet PRO base station”
on page 6.
Temperature measurement
units – change to Celsius or
Farenheit degrees.
AUTO / MANUAL – change
the CO
²
calibration mode to
either manual (default
position) or automatic mode.
The positions of the
configuration switches have
the following meaning:
AUTO
MANUAL
°C
°F O
(OFF)
O
(OFF)
To Next Page
Loading...
