9
Storage of the Tent
1.
If the tent is stored on the vehicle for extended periods and is exposed to the elements, it is possible for the
tent to absorb moisture from the air into the canvas fabric. For this reason, the tent should be opened
periodically and allowed to air or dry. It is not recommended to store the tent on the vehicle during winter
months or periods of extended rain. The ladder can remove separately to lower the overall height of your
vehicle.
2.
When storing the tent off the vehicle, ensure the tent is packed away completely dry and kept out of direct
sunlight. If the tent is stored in humid conditions, unzip or remove the travel cover to allow the canvas to
breath and dry. It is recommended to store the tent indoors in a warm, dry environment.
3.
Be careful not to drag the tent on the ground. This will damage the cover and allow potential water ingress
the next time you use your rooftop tent.
4.
Do not store directly on a concrete floor.
5.
The Ladder can be removed from the Tent when you are not camping and the tent is on in just general vehicle
use, this will help keep the ladder in good condition and also help reduce your height and improve aerodynamics.
This is a feature of the tent that the ladder does not need to be kept on while the tent is in transit.
6.
Mold and Mildew is not a defect or manufacturing fault, if the tent was found to be stored or packed up wet
and not dried correctly then a full review of the warranty will be required.
Care Instructions
1.
Clean all parts of the tent with cold water and a soft brush only - do not use soap or detergent as these may
damage the coating on the fabric, or cause corrosion to metal and alloy parts. Pay particular attention to remove
dirt, bird droppings and vegetation such as leaves as these can cause the tent to rot when packed away.
2.
Clean the travel cover regularly to reduce the effects of acid rain and other air born contaminants. To extend the
life of the PVC cover, regularly treat with a UV protectant such as ‘303 Aerospace Protectant’ or ‘Armor All
Protectant’. Keep harsh chemicals away from the Tent cover, Example Truck Wash.
3.
Do not expose any part of the tent to petrol, oil, solvents, harsh cleaning products or similar.
4.
Zippers should be cleaned regularly by brushing with a soft brush and wiping with a damp cloth. Zippers that
become stiff to operate may be lubricated periodically with commercially available zipper lubricant or
paraffin wax. Note: Do not over lubricate as this may attract dust and debris.
5.
New poly/cotton canvas may initially experience some weeping through the seams. This will reduce
over time as the fabric cures. In a weep occurs its best to treat the weep with a seam sealer, these
can be purchase from good camping supply stores.
6.
Well-worn fabrics may be re-proofed using a good quality waterproofing solution.
7.
Always air your tent before and after use to allow any moisture or condensation to dissipate. The travel cover
has welded seams and is near water tight to keep the elements out. As soon as the travel cover is fitted and
warms up in sunlight it can heat any trapped moisture which will create an environment where mould, mildew
and rot can set in quickly. Please make sure you dry your tent completely before pack up.
8.
If mould and mildew is found on any part of the tent fabric, allow the tent to dry thoroughly in the sun to
prevent it spreading. Use a soft bristled brush to remove any particles. Mildew remover may be effective but test
first on an obscure part of the tent fabric. DO NOT use any bleach solutions on the fabric as they may discolor
the tent and damage the PU coating on the fabric. The best cure for mould and mildew is to prevent its growth in
the first place by ensuring the tent is packed and stored thoroughly dry.
6.
Cautions, Storage and Care guide lines continued
To Next Page
Loading...
