30 / JACK Instruction Manual 3789833-20200901
Original Instruction
2. JACK OIL LEAK AND SPILLAGE
The Jack uses W Hydraulic mineral oil, this fluid is only toxic if ingested. If contact with hydraulic fluid
occurs, wash your hands thoroughly prior to contact with food or drinks.
Avoid oil interacting with any rubbers, vehicle paint, plastic or upholstery.
Promptly clean oil spillages using warm soapy water, then rinse immediately with fresh water.
Jack is filled with 1.1 Litres of oil
Jack never needs more than approx. 990mls; the extra fluid ensures that the pump always has enough
fluid. Small leaks won’t need to have Jack topped up.
To ensure Jack has enough fluid:
• Raise Jack to full extension without load
• If Jack reaches its end stop without any air sucking noises, it has suficient fluid and does not need to
be refilled
• If Jack does not reach full extension, or begins to produce “air sucking” or “gurgling” noises during
pumping, Jack may need extra fluid to operate to its full extension
• Topping up the fluid requires disassembly, and must only be done by authorised service personnel, as
incorrect disassembly/reassembly may cause Jack to malfunction
NOTE: Topping up with excess fluid may cause malfunction, including leakage and inability for Jack to
lower fully.
JACK SPECIFICATIONS
Min. Liting Height 160mm / 6.3"
Max. Liting Height 710mm-1230mm / 27.9"-48.42"
Travel 540mm / 21.25"
Liting Range 160mm-1230mm / 6.3"-48.42"
Compressed Height 890mm / 35"
Extended Height 1432mm / 56.3"
Weight 10.5kg / 23.15lb
Lit per Stroke 13mm / 0.51"
Max. Liting Capacity 2000kg / 4409.25lb
Fluid W Hydraulic Mineral Oil
Fluid Capacity 1.L / 1.16qt
To Next Page
Loading...