Need help?Do you have a question about the ARC Audio 2100 XXK and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 100W x 2 |
| RMS Power at 2 Ohms | 200W x 2 |
| Bridged RMS Power | 400W x 1 |
| Signal-to-Noise Ratio | >100dB |
| THD at Rated Power | <0.05% |
| Damping Factor | >200 |
| Power Output (RMS) | 100W x 2 @ 4 Ohms, 200W x 2 @ 2 Ohms, 400W x 1 @ 4 Ohms Bridged |
| Crossover | Variable 55Hz - 5.5kHz |
Covers regulated power, protection circuits, and MOSFET isolation.
Critical steps for establishing a secure chassis ground connection.
Explains how power supply affects amplifier output and vehicle charging system needs.
Wiring and settings for Full Range and Stereo configurations.
Wiring and settings for Low Pass and Bridged/Mono configurations.
Wiring and settings for Stereo and Full Range modes on the 4050XXK.
Wiring and settings for a 2 Ohm per channel configuration.
Wiring and settings for a 4 Ohm bridged mono configuration.
Wiring and settings for the 5150XXK amplifier.
To Next Page
