Arcam CDS50 - Rear Panel Connections; Power Inlet and Antenna Port; Network, RS232, and USB Ports; Digital and Analogue Audio Outputs

EN
EN-7
Rear Panel Connections
ANT
RS232NET
USB
5V 0.5A
DIGITAL OUT
OPT R
IR IN TRIG IN
COAX
DIGITAL IN
OPT COAX
ANALOGUE OUT
L
R
L
POWER INLET
100V-240V~
50/60Hz, 17W
POWER INLET
Connect the correct
mains cable here
USB
Insert USB flash memory devices here.
See “USB” on page EN-9
Wi-Fi ANTENNA
Connect the supplied Wi-Fi antenna
DIGITAL AUDIO INPUTS
Connect a digital audio source
See “Digital Audio Inputs” on page EN-9
NETWORK
Connect to your home network router
See “Network” on page EN-9
RS232
Connect to a third party home automation
system
See “RS232” on page EN-9
ANALOGUE AUDIO OUTPUTS
Connect to the audio input of your amplifier.
See “Analogue Audio Outputs” on page EN-9
Please read the sections “Placing The Unit”, “Power” and
“Interconnect Cables” on page EN-6 before connecting your
CDS50 player!
REMOTE IR IN
Connect to an external remote control device
See “Remote IR Control” on page EN-9
12V TRIGGER IN
Connect to the TRIGGER OUT of a compatible
device, to allow the CDS50 be switched in and
out of standby
See “Trigger In” on page EN-9
DIGITAL AUDIO OUTPUTS
Connect to the digital inputs of your AV
receiver
See “Digital Audio Outputs” on page EN-9