Arcam DV79 - Technical Specifications; General and Video Specifications; Audio and Accessory Specifications

DV79
E-24
English
DV79
E-25
Technical specications
General
Power Requirements 100/115V or 230V AC,
set by voltage selector switch on rear panel
Power consumption < 35 VA
Dimensions 435mm x 80mm x 350mm
Weight net: 5.2kg; packed: 8.0kg
Video outputs
Composite video 1 x gold plated phono. 1V pk-pk in 75Ω
S-Video 1 x 4-pin mini-DIN. Y 1V pk-pk in 75Ω, C 0.3V pk-pk in 75Ω
Component video Interlaced or Progressive
3 gold plated phono sockets.
Y 1V pk-pk in 75Ω, Pb 0.7V pk-pk in 75Ω, Pr 0.7V pk-pk in 75Ω
SCART socket with RGB video All 0.7V in 75Ω, composite video 1V in 75Ω, and stereo audio
Auto switching of TV with aspect ratio control
HDMI 19-pin HDMI connector
Supported video formats are:
720x576p, 720(1440)x576i, 720x480p, 720(1440)x480i,
all with basic audio.
Audio outputs
Analogue audio outputs Stereo or multi-channel output on gold-plated phono sockets
Output level 2.2V rms at 0dB signal,
4V rms with HDCD discs (left and right channels only)
Frequency response 20Hz to 20kHz (+0.1db, –0.5dB)
THD+N <0.005% for 1kHz 0dB signal,
measured 22Hz–22kHz, unweighted
Signal-to-noise ratio 105dB, measured 20Hz–20kHz, unweighted
Digital audio output (IEC958) PCM/Dolby digital/MPEG/DTS on gold plated phono (coax) and
TOSLINK (optical)
Accessories supplied
CR-415 Remote control
2 x AAA batteries
mains lead
E&EO
NOTE: All specication values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and
specications are subject to change without notice.