Arcam RCUBE - Upgrading the Firmware; Firmware Download and Preparation; Firmware Update Process

5. UNDO iPOD PCB SCREWS &
REMOVE RETAINING BAR,
GROMMETS & PCB
6. FIT GROMMETS TO NEW PCB &
REVERSE REMOVAL INSTRUCTIONS...
4. DISCONNECT FLEXFOILS &
HINGE DOCK FULLY UPWARDS
3. HINGE DOCK UPWARDS TO
REVEAL FLEXFOIL CABLES
TO REPLACE iPOD PCB
!! ANTI-STATIC PRECAUTIONS MUST BE TAKEN TO AVOID DAMAGE TO ELECTRONIC COMPONENTS
!!
2. SLIDE DOCK REARWARDS
AGAINST SPRING PRESSURE
1. PARTLY OPEN DOCK FLAP
1. REMOVE RUBBER FEET FROM BASE OF UNIT
2. REMOVE SCREWS & BASE COVER
TO REPLACE BATTERY
3. REMOVE BATTERY & RELEASE CONNECTOR
4. FIT NEW BATTERY & CONNECTOR
& REVERSE REMOVAL INSTRUCTIONS
FIT NEW SELF-ADHESIVE FEET SUPPLIED
DANGER OF EXPLOSION
IF BATTERY IS
INCORRECTLY
REPLACED.
REPLACE ONLY WITH
THE SAME OR
EQUIVALENT TYPE.
CAUTION