My rDAC/rWave is plugged into my PC, has the green USB indicator (rDAC only), is selected as the playback device, but
still I get no audio. What gives?
It has been observed during product development and testing that some operating systems occasionally require manual intervention in order for the rDAC/rWave to
install successfully. is is most likely to occur if the rDAC/rWave is plugged into a dierent USB port on a PC to where it was previously connected.
Windows XP exhibits this issue. e remedy is to “un-install” the device from the operating system to give Windows XP a clean start when the rDAC/rWave is next
attached. Follow these instructions (with the rDAC/rWave connected) to remove the rDAC/rWave from Windows XP, then re-attach the rDAC/rWave.
1) Via the Control Panel, select System. In the System Properties, select the
Hardware tab. Click the button Device Manager.
2) In the Device Manager, under the View menu, turn on the option Show
Hidden Devices.
To Next Page
Loading...
