EN-8
OPERATION
Play Music With Chromecast built-in
1. Launch the Chromecast built-in enabled app on your phone or tablet.
2. Press the icon in the app and select the Solo Uno.
3. Press “Play” in the app.
Using AirPlay on your iOS device
1. Locate and press the icon on your iOS device.
2. Choose the Solo Uno as the AirPlay speaker.
3. Select your music and start playing.
Using the AUX input
To use the input press and hold the key for approx 3 seconds and release. The STATUS LED will
change to GREEN.
The input is active until either an AirPlay or GoogleCast audio stream is sent to the Solo Uno.
Upgrading the Solo Uno software
The Solo Uno will automatically download any available software updates when it is connected to a
network.
If the Solo Uno is left powered on these updates will be installed over night when the unit is idle.
If the unit is powered o over night then the update will installed the next time the unit is powered on.
The NET LED will double ash BLUE to indicate the update is in progress.
Resetting the Solo Uno
To reset the Solo Uno without loosing any stored settings simply press the button on the rear panel
for less than 1 second. The LEDs will change state to indicate the unit is restarting.
To restore the Solo Uno to factory defaults including forgetting any stored WiFi networks press and hold
the button on the rear panel for more than 3 seconds. Both LEDs will briey light BLUE to indicate
factory reset has been inititated.
To Next Page
Loading...