EN-12
IMPORTANT ANTENNA INFORMATION
The Solo Uno is only designed to operate with the supplied antenna. Any other antenna is strictly prohibited for use with the Solo Uno.
FCC Information (for US customers)
1.  PRODUCT
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
2.  IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modication not expressly 
approved by ARCAM may void your authority, granted by the FCC, to use the product.
3.  NOTE
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. 
If this product does cause harmful interference to radio or television reception, which can be determined by turning the product OFF and ON, 
the user is encouraged to try to correct the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the product into an outlet on a circuit dierent from that to which the receiver is connected.
•  Consult the local retailer authorized to distribute this type of product or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed 
and operated with minimum distance 20cm between the antenna and your body.
INDUSTRY CANADA Information (for CANADIAN customers)
This Class B digital apparatus complies with Canadian ICES-003
1.  "This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this 
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired 
operation of the device. 
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est 
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout 
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement"
2.  "This radio transmitter 6132A-LUXASTR01 has been approved by Industry Canada to operate with the antenna types listed below with 
the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, 
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. 
Le présent émetteur radio  6132A-LUXASTR01 a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés 
ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans 
cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur." 
 
Wanshih WSS002, Antenna Gain +2dBi
3.  "This equipment complies with IC RSS102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be 
installed and operated with minimum distance 20 cm between the antenna and your body. 
Cet équipement est conforme aux limites IC RSS102 d'exposition aux rayonnements dénies pour un environnement non contrôlé. Cet 
équipement doit être installé et utilisé à distance minimale de 20 cm entre l'antenne et votre corps."