ARCBRO Stinger Series User Manual (English)

Other manuals for ARCBRO Stinger Series

Questions and Answers:

Jamie GrahamAug 2, 2025

What to do if ARCBRO Cutter torch doesn't move along one axis?

B
brandon46Aug 2, 2025
If the ARCBRO Cutter torch doesn't move along one axis and ignores keystrokes, the machine operation might be interrupted. First, remove any interference and ensure the plasma power supply's grounding wire is connected to the machine. Next, check if the motor (previous model) has an isolation board. Finally, if it's in flame mode, verify if the solenoid valve for cutting oxygen is causing arc extinction.

Parker GarciaAug 18, 2025

Why does the motor fail to run on my ARCBRO Stinger?

S
simpsonrichardAug 18, 2025
If the motor fails to run on your ARCBRO Cutter, there are several potential causes to investigate: * Check for loose or disconnected connections and secure them. * Examine the driver settings and change them if they are incorrect or if there is an alarm message. * Verify that the start speed isn't zero or too high, the speed regulation time isn't too short, and the electronic gear or pulse equivalency isn't inappropriately set to zero. It's recommended to record the original parameters before making any modifications.

Brand

Model

Stinger Series