4
CONTROL PANEL ON THE UNIT
1
2
3
4
5
Power on
indicator light
Continuous
operation on
indicator light
Bucket full
indicator light
High fan
indicator
light
Normal fan
indicator light
Control Panel
1
POWER Button
Press to turn the unit on or off.
2
Continuous Button
Select for the dehumidifier to operate
continuously for maximum dehumidification
until the bucket is full. The Humdity can not
be set when Continuous operation is on.
3
Humidity Set Control Buttons
The humidity level can be set within a
range of 35%RH(Relative Humidity) to
80%RH(Relative Humidity) in 5%
increments.
For drier air, press the button and set
a lower percent value(%).
For moister air, press the button and
set a higher percent value(%).
4
Fan Speed Buttons
Press to select either Turbo or Normal fan speed. Set
the fan speed to Turbo for maximum moisture removal.
When the humidity has been reduced and quiet operation
is preferred, set the fan speed to Normal.
5
Display
Shows the set humidity level( while setting, then shows
the actual(+5% accuracy) room humidity level ( .
Error Codes:
E1- Humidity sensor error--Unplug the unit and plug it back
in. If error repeats, call for service.
E2- Temperature sensor error-- Unplug the unit and plug it
back in. If error repeats, call for service.
P1- Unit is defrosting-- Unit will take time to automatically
defrost. The error will clear after the unit defrosts.
P2- Bucket is full-- Empty the bucket and replace in
the proper position.
%)
%)
Other Features
Bucket Full Light
Lights up when the bucket is ready to be
emptied, or when the bucket is removed
or not placed in proper position.
Auto Shut Off
The water level control switch shuts off the
unit when the bucket is full, or when the
bucket is removed or not placed in proper
position.
When the set humidity is reached, the unit
will also be shut off automatically.
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue to
run until the frost disappears.
Auto Restart
In the case of power outage or interruption, the unit will
automatically restart and restore previous setting after
the power is back on.
Auto Defrost
C
Power
Continuous
Full
Humidity%
Turbo
Normal
Fig.1
To Next Page
Loading...