Operating Instructions:
Low Temperature Freezing Cabinet
For safety reasons, these operating instructions should be read before the freezer is commissioned. The
operating instructions should always be available to and accessible for the personnel!
Instruct the personnel in the use of the freezer. There is a risk of frostbite if the contents or the sides of the
inner container are touched!
In the event of breakdown or irregularities contact professional instructors or repair technicians immediately.
Installing the Freezer
1. Always let an authorised electrician install the freezer (read the operating instructions).
2. The freezer should be located in a dry, cool place, out of direct sunlight. The freezer gives off a great
deal of heat when in operation. If the ambient temperature is too high, there is a risk that the freezer
will not operate correctly. Always ensure that the room is proper ventilated, so that the room
temperature does not exceed 25° C at most. Class N.
3. Place the freezer on a solid and flat substrate. This will eliminate any vibration and irritating noise. The
freezer should be placed with at least 30 cm free to the sides and against the wall.
Electrical Connection:
The machine meets current EU directives. Low voltage 2006/95/EEC.
Electromagnetic compatibility 2004/108/EEC.
The machine should be given extra protection in accordance with the Electricity Supply Regulations in order
to protect the user against dangerous electric shocks in the event of faults.
If the switch is for a three-pin plug, a three-pin plug should be used, and the conductor with yellow/green
insulation should be connected to the Earth terminal marked E.
Data regarding voltage and absorbed power / current are given on the rating plate.
Electrical connection must be made in accordance with the local regulations.
5
IMPORTANT!
Please remove the styropor plate witch is placed between the two
condenser coils on the back of the freezer before commissioning
the freezer!
To Next Page
Loading...