ARCTICO UPLTF 90 - Warning; Before Commisioning; Start Procedure; Caution

Warning-Regulations require that this appliance must be earthed:
The manufacture declines all liability for injury to persons or animals and for damage to property resulting
from failure to observe the above procedures and reminders.
If the socket and plug are not of the same type, please have the plug or socket replaced by a qualified
electrician.
Do under no circumstances use extension leads or adaptors.
1. The freezer should be connected by an authorised electrician, or by the company, which sold the
freezer! Incorrect installation may damage the freezer.
2. Place the freezer on a flat floor, which can take the weight of the freezer.
3. The electrical installation should be earthed.
4. Do not use extension cables, but connect the freezer directly to a fixed installation. If the freezer is
connected to a long extension cable there is the risk that the cable will become hot.
5. The freezer should be placed in a dry location, and should not be subjected to water on the cabinet. If
water gets into the electrical parts it may cause short-circuiting.
6. In the event of functional or electrical irregularities please contact an authorised servicing engineer
Before Commissioning:
Clean the freezer both inside and out using a damp, wrung out cloth. Dry with a dry cloth.
The smell from the plastic parts in the freezer will disappear once the freezer has been cooled down.
Start Procedure
Put the plug in the socket. The freezer should run for at least 1 hours before the thermostat is changed.
(Stabilisation of the cooling system).
Caution!
Do not place bottles or boxes containing carbonic acid or chemical agents in the freezer.
Do not place inflammable liquids such as ethane, petrol or alcohol in the freezer. Risk of explosion!
No bottles or tins should be placed in the freezer, as they could explode and cause injury to personnel.
Always use thermal gloves when operating the freezer, to reduce the risk of frost-bite.
In the event of repair work or corrective action in the installation in the machine room,
the plug should always be removed! Repair work in the installation should be carried
out by an authorised electrician!
6