FX DETAILED MANUAL
11
7. What happens when something goes wrong? Or it seems like the cycle is running too long?
Manually end the Cycle (
see the Quick Start guide’s #5 for instructions)-- then contact us at
support@ardentcannabis.com. if anything seems amiss it is always best to contact us right
away so we can help!
8. What if I accidentally end my decarb cycle early (power goes out, etc.) - what should I do?
Estimate about how long the decarb cycle was running for and subtract it from two hours.
Re-run the cycle for this length of time and manually end it (see step 5
)
9. What about CBD? And about CBG?
CBD can be activated easily using the same steps as THC, except using the A2 setting. CBG
can be activated easily using the same steps as THC, using the A1 setting.
Our education section has all of our most current research, for instance:
Check out an easy CBD activation and infusion here:
Safe and economical CBD DIY products here:
10. These edibles feel different then the edibles I usually make with my oven - why?
Some of our customers are very used to CBN, a cannabinoid present when over decarbing
like when smoking or using an oven. CBN can often feel heavier and more body-heavy and
can be increased in your product by running your THC material twice. You are in control of
the cannabinoids you want to receive!
11. Precision decarboxylation and infusion are new to me - I don’t want to put my whole batch
in at once - what if I make a mistake?
There is no minimum in the device - so always feel free to experiment with small amounts! In
fact - that is what we recommend anytime you are trying something new whether it be a new
machine, new oil, or a new recipe.
12. Does it smell a lot?
No the unit is odorless - unless you are standing right over it taking a big sniff ;) If your unit
seems to be sharing its odor more than it should be please reach out and let us know so we
can help! To minimize smell, let the unit cool fully before removing your perfectly decarbed
product as the hotter air releases more smell into the environment.
13. Can I use alcohol in the device?
In short, No. Since alcohol alone is a strong enough solvent to almost instantly infuse,
there's no need for heat during the process. Most importantly, mixing heat and alcohol is
dangerous and puts you at risk; Alcohol should never be heated in the FX.
To Next Page
Loading...