ARDES A130D - Page 7

6
ENGLISH
IMPORTANT SAFETY PERCAUTIONS：
1. Before wiring the paddle fan, turn off the electric power supply at the main
fuse box or main circuit breaker and leave it off until installation is complete.
2. The outlet box and support structure must be securely mounted and capable
of reliably supporting a minimum of 35 pounds. Use only metallic outlet boxes.
3. Do not install paddle fan less than 2.3m between floor and lowest edge of fan
blades.
4. Never attempt to stop the fan blades when it is in operation
5. All wiring must be in accordance with the National Electric Code and local
electrical codes. Electrical installation should be performed by a qualified
licensed electrician.
6. Do not operate reversing switch while fan blades are in motion. Fan must be
turned off and blades stopped before reversing blade direction.
7. Avoid placing objects in the path of the blades.
8. Do not use water or detergents when cleaning the fan or fan blades. A dry
dust cloth or lightly dampened cloth will be suitable for most cleaning. Turn off
the electric power supply before cleaning.
9. After making electrical connections, spliced conductors should be turned
upward and pushed carefully up into outlet box. The wires should be spread
apart with the grounded conductor and the equipment-grounding conductor
on one side of the outlet box.
10. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
11. Children should be supervised to ensure that they do not play with the
appliance.
OPERATING INSTRUCTIONS
1. Turn on power and check operation of fan. The pull chain controls the fan as
follows: One pull-high speed; two pulls-medium speed; three pulls-low speed;
four pulls “off ”
2. If regulator speed controls being applied, the regulator controls the fan as
follows; Turn control knob to position“3”(high speed), then decrease as
required in steps to position “1” (low speed).
3. The slide switch controls “ FORWARD” and “ REVERSE”. Be sure turn off the
power source before reverse the fan.