ARDES AR1K3000 - Use of the Appliance

24/29
26 / 88
and the smoke will no longer be emitted within a few minutes.
Ventilate the room during the first operation.
First test ignition
- Place the appliance on a stable, flat, horizontal, and heat-resistant
surface;
- Close the appliance door;
- Connect the plug to a grounded power socket;
- The spy will flash.
- Set up and run the DIY program as follows:
1. Press the bottom
to turn on the display;
o Note: If no button is pressed within 30 seconds, the display
turns off, and the indicator light flashes.
2. Press the bottom and select the DIY program;
3. Press the bottom , use the bottoms to set the temperature
to 200 ° C;
4. Press the bottom , use the bottoms to set the time to 10
minutes;
5. Press the bottom to start the operation. The appliance starts to
work, and the interior light will light.
- At the end of the program, the appliance will emit a "BEEP" 5 times, and
the display will turn off.
The fan will remain active for approximately 30 seconds.
- After the fan has stopped, disconnect the socket’s plug and let the
appliance cool down.
USE OF THE APPLIANCE
Note: before using the oven for the first time, perform the operations indicated
in the paragraph "Before using the appliance."
- Place the appliance on a stable, flat, horizontal, and heat-resistant
surface;
- Insert the dripping pan (11) into the oven;
- Place the ingredients on the grill (12), on the rotating basket (15), or on
the rotisserie (13);
- Insert the chosen accessory into the appliance and close the door;
- Connect the plug to a grounded power outlet.
- The indicator light will flash.