ARDES AR5EA50PB - Technical Informations

10
Technical informations
1. Unscrew the screw and take out the washer (16) from the base rod
(14).
2. Insert the base rod (14) into the base’s hole (15).
3. Turn over the base (15) so the base rod (14) is pointing the oor then
place the washer into the hole on the bottom of the base and tighten it
rmly with the screw (16). Turn over the base again with the base rod
xed.
4. Unscrew the height adjustment knob (13) from the base rod (14) and
pull the adjustment rod (12) out from the base rod (14). Tighten the height
adjustment knob (13) on the base rod (14).
5. Loosen the screw of the main body (11).
6. Insert the main body on the adjustment rod (12). Tighten the screw
(11) to secure it.
7. Unscrew the lock ring of the fan (2) from the motor shaft (7) by turning
it clockwise.
1. Front grille
2. Lock ring of the fan
3. Safety screw of the fan
4. Fan
5. Lock ring of the back grille
6. Back grille
7. Motor shaft
8. Oscillation knob
9. Motor
10. Control panel
11. Main body screw
12. Adjustment rod
13. Height adjustment knob
14. Base rod
15. Base
16. Washer and screw
A-B. Locking pin for the rear
grille
Assembling
9
3
4
7
1
2
5
6
8
10
11
12
13
14
15
16
A
B