33 / 44
FIRST USE
Before using this oven, please ensure that you have read the instruction manual fully
and have become familiar with important safeguards.
WARNING:
Before using the appliance for the first time, clean it and wash the accessories in
as specified in MAINTENANCE section.
It is necessary to do two trial runs of your oven to eliminate any protective substance
on the heating elements.
Conduct the trial run in a well-ventilated area as a small amount of smoke and
odor may be detected. This is normal and should be expected.
First trial run
- Ensure that the water tray (9) is in position.
- Remove the tank (6) by pulling its handle.
- Fill the tank, do not fill over the MAX level showed on the tank, close the top and
push the tank in its site
- Remove the accessories from the cavity and close the door (7).
- Plug the oven into a standard 220-240V grounded outlet;
- Set and run the DIY program as following:
1. Press the ON/OFF key ; the display will lights on;
2. Use these keys to select the DIY program , then press the
ENTER key ;
3. Use these keys to select the Strengthening heating function ,
then press the ENTER key ;
4. Set the time:
Use these keys to adjust the hours of working
to “0”, then press the ENTER key
Use these keys to adjust the minutes of
working to “30”, then press the ENTER key ;
5. Set the temperature of the top heater pipe:
Use these keys to adjust the temperature to
“230 °C”, then press the ENTER key
6. Set the temperature of the bottom heater pipe:
To Next Page
