16 / 56
NOTE: changing the cooking time, the "SMART" function, if active, could be deactivated
because it cannot be adapted to the new parameter (in this case, the relative icon will switch
off).
To select another program, press the key and repeat points 5 to 9.
NOTE: by modifying the cooking program, the "SMART" function, if active, could be
deactivated because it cannot be adapted to the new parameter (in this case, the relative icon
will switch off).
To temporarily stop cooking:
12. Press the key to temporarily interrupt cooking (pause).
To temporarily stop cooking just one of the containers, first press the or key to
select the corresponding container and then press the key. .
Press the key again to continue cooking.
NOTE: when cooking is paused, if no operations are performed within a few minutes, the
program is cancelled and the appliance (or the selected container) enters standby mode.
To end the cooking program:
13. Press the key for approximately 3 seconds to end the program.
To end the program corresponding to only one of the containers, first press the or
key to select the corresponding container and then press the key for approximately 3
seconds.
NOTE: when the program is interrupted, the display shows “OFF” for a few seconds.
NOTE: some programs require the food to be shaken or turned upside down halfway through cooking
(see the “PROGRAMS AND SETTINGS” paragraph). In this case, at the appropriate time, the appliance
emits 3 short beeps, the icon corresponding to the container to be mixed flashes and then remains
lit. Remove the container from the appliance, being sure only to touch the handle; the program stops
momentarily when the container is removed and the display shows "OPEN"; shake the container (or
turn the food upside down) and put it back in the appliance; the fryer reactivates as soon as the container
is reinserted and the cooking cycle resumes from the moment in which it was interrupted and the icon
switches off.
NOTE: use the handles and be careful not to touch the containers and the inside of the appliance to
avoid burns.
End of cooking
- Once the time has elapsed, the timer beeps, the display shows “OFF” and the appliance switches off.
- Remove the container and check that cooking is completed; otherwise, reinsert the container and set
a few more minutes by repeating operations 5 to 9.
- After cooking, remove the container (or containers) (1)(2) and pour the food into a suitable, heat-
resistant container.
NOTE: use the handles and be careful not to touch the containers and the inside of the
appliance to avoid burns.
- Put the container (or containers) (1) (2) back into the fryer.
- Disconnect the appliance from the power outlet and let it cool down.
- Clean the container and the basket as indicated in the “CLEANING AND MAINTENANCE” paragraph.
To Next Page
Loading...
