19 / 56
To clean the heating resistor, use a brush or a dry cloth to remove any food residue.
To clean the baskets (3)(4) and the containers (1)(2), use hot water, washing up liquid for washing
dishes by hand and a nonabrasive sponge; DO NOT WASH IN THE DISHWASHER.
Do not clean the container, the basket and inside the appliance with metal tools or abrasive materials
to avoid damaging the non-stick coating.
Do not use the appliance if the non-stick coating is damaged.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
(EN) TROUBLESHOOTING
Problem Cause Solution
The appliance does not work Timer off Set timer
The chips are not cooked Too much food in the basket Reduce the quantity of food in
the basket
The temperature set is too low Increase the cooking
temperature
Food is not evenly cooked During cooking, the food was
not mixed
Cook for another few minutes,
keeping the food mixed and
see “PROGRAMS AND
SETTINGS”
The fried food is not crispy Food was used which is
suitable for a traditional oil
fryer.
Use food suitable for oven
cooking or consult
“PROGRAMS AND
SETTINGS”
White smoke is coming from
the appliance
Fatty ingredients As indicated in “PROGRAMS
AND SETTINGS”, avoid
cooking excessively fatty food
The container contains fatty
residue from previous used
Clean the container and/or
basket well after each use
The display shows “E1” NTC open Turn off the appliance, and
remove the plug from the
socket. Contact assistance
The display shows “E2” NTC shortcircuited Turn off the appliance, and
remove the plug from the
socket. Contact assistance
(EN) DISPOSAL
PACKAGING
To respect the environment, the packaging material must be disposed of correctly, respecting separate
collection.
Check the provisions of your municipality.
USER INFORMATION
“Implementation of Directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE)”, pertaining to reduced use of hazardous substances in electrical and electronic
equipment, as well as to waste disposal.
The symbol of the crossed-out wheelie bin on the equipment or on its packaging indicates
that the product must be disposed of separately from other waste at the end of its service life.
The user must therefore take the dismissed equipment to suitable separate collection centres for
electrical and electronic waste.
For more details, please contact the appropriate local authority.
Suitable segregated collection of the equipment for subsequent recycling, treatment or environmentally-
friendly disposal helps prevent damage to the environment and to human health, and encourages the
re-use and/or recycling of the materials that make up the equipment.
To Next Page
Loading...
