ARDESTO YCM-E1600 - EQUIPMENT; BEFORE THE FIRST USE

30
EQUIPMENT
1. Complete coee maker - 1 pc.
2. Instruction manual - 1 pc.
3. Warranty card (included in the manual) - 1 pc.
4. Packaging (plastic bag + box) - 1 pc.
BEFORE THE FIRST USE
To ensure the rst cup of coee tastes excellent, you should rinse
the coee maker with warm water as follows:
1. Pour water into water tank, the water level should not exceed the
“MAX” mark in the tank.
NOTE: The appliance is supplied with a detachable tank for easy
cleaning, you can ll the tank with water rstly, and then put the
tank into the appliance.
2. Set steel mesh into metal funnel (no coee powder in steel mesh).
3. Place a jug on removable shelf. Make sure the steam control knob
is on the “OFF” or “0” position.
NOTE: The appliance is not equipped with jug, please use yourself
jug or coee cup.
4. Connect to power source, turn the ON/OFF switch to the “1”
position. The red lamp will be illuminated.
5. Pressing the steam switch to the “0” position and coer/hot water
selector to the “1” position the pump will pump water, when there
is water owing out and pressing the coee/hot water selector to
the “0” position and waiting for a moment, the appliance begins
to be pre-heated until the green lamp is illuminated, it shows the
pre-heating is nish. Pressing coer/hot water selector to the “1”
position again, and water will ow out.
6. After water not dropping out any more, you can pour the water
in each container out then clean them thoroughly, now you can
start brewing.
EN