31
NOTE: There may be noise when pump the water on the rst time,
it is normal, the appliance is releasing the air in the appliance. After
about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coee, we recommend
you preheating the appliance before making coee, including
the funnel, lter and cup, so that the coee avour can not be
inuenced by the cold parts.
1. Remove the detachable tank and open the tank cover to ll it
with desired water, the water level should not exceed the “MAX”
mark in the tank. Then place the tank into the appliance properly.
2. Select the one-cup or two –cup mesh, set stainless steel mesh
into metal funnel, pull the press bar backward, make sure the
tube on the funnel aligns with groove in the appliance, then
insert the funnel into the appliance from the “Insert” position
and release the press bar, and you can x them into coee maker
rmly through turn it anticlockwise until it is at the “lock” position.
3. Place an espresso cup (yourself cup) on removable shelf.
4. Then connecting the appliance to power supply source. Make
sure the steam control knob is on the “OFF” or “0” position.
5. Press the ON/OFF switch to “1” position, the red lamp will be
illuminated, make the coee/hot water selector on the “1”
position. Press the steam switch on the “0” position, when there
is water owing out, close the pump (pressing coee/hot water
selector on the “0” position) immediately. The purpose of the step
is that pump the water of the tank into the housing.
6. When the green lamp is illuminated, you should press the coee/
hot water selector on the “1” position again, there will be hot
water owing out. When the green lamp is extinguished, close
the pump. The pre-heating is nished.
EN
To Next Page
Loading...