32
MAKE ESPRESSO COFFEE
1. Remove the funnel by turning it in clockwise. Add ground coee
to steel mesh with measuring spoon, a spoon ground coee power
can make about a cup of top-grade coee, then press the ground
coee powder tightly with the tamper.
2. Set steel mesh into metal funnel, pull the press bar backward, make
sure the tube on the funnel aligns with groove in the appliance,
then insert the funnel into the appliance from the “Insert” position
and release the press bar, and you can x them into coee maker
rmly through turn it anticlockwise until it is at the “lock” position.
3. Pour out the hot water in the cup. Then place the hot cup (yourself
cup) on removable shelf.
4. At the time, the green lamp is illuminated, if the green lamp
is extinguished, wait for a moment, once the green lamp is
illuminated, and you should press the coee/hot water selector on
the “1” position, waiting for a moment, there will be coee owing
out.
NOTE: During operation, if the green indicator is extinguished, you
must close the pump and stop to make espresso coee. After a
few seconds, if the green lamp is illuminated again, you can make
espresso coee continued by pressing coee/hot water selector to “1”
position, the green lamp is cycle ON and OFF to maintain the water
temperature is hot enough.
5. You should press coee/hot water selector to “0” position manually
when desired coee is obtained or the colour of coee changes
weak obviously, the red and green indicator go out and the coee
maker stops working, your coee is ready now.
WARNING: Do not leave the coee maker unattended during making
the coee, as you need operate manually sometimes!
6. After nishing making the coee, you can take the metal funnel
out through turn anticlockwise, and then pour the coee residue
out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
EN
To Next Page
Loading...