SM753
USING THE WASHING MACHINE
Warning: Before proceeding with the first wash, it is advisable to carry out a brief
washing cycle without any laundry in the machine. This will enable you to
ensure that the machine operates correctly and the tub will also be cleaned
in this way.
Precautions and warnings, before beginning washing cycle:
- Ensure that the plumbing tubes are positioned correctly: the water tap must be
open and the water tube must be in the correct position (see assembly chapter and
diagrams 4-7)
- Ensure that the programming dial is in the stop position.
- Insert, with dry hands, the plug into the socket.
- Sort the laundry, separating it according to the fabric type (check the labels on the
garments)
- Before loading the laundry into the tub ensure that:
- The pockets of the garments are empty
- Any ripped seams have been mended
- Any closures, zips, belts or hooks are closed.
- Any stains have been treated.
The washing cycle:
(By following these instructions, the washing machine will carry out the washing cycle,
which has been imposed).
1. Open the door of the machine.
2. Load the laundry into the tub and close the door.
WARNING: It is prohibited to overload the machine. It is advisable to hand wash
garments that absorb an enormous amount of water (for example: rugs).
3. Pour the washing powder (which must not produce too much foam) and the fabric
softener for automatic washing machines into the respective drawers (see chapter
entitled: “Use of Detergent”)
4. Close the detergent drawer.
N.B. Do not remove the detergent drawer while the machine is in use, because this
may cause the water to flow out).
5. Choose and set the desired washing cycle program and temperature using the
relative knobs.
WARNING!! Do not turn the programming knob to the left. If you pass the desired
program, continue to turn to the right until you reach the desired position again.
6 Press the pushbuttons that correspond to the selected functions.
7 To start the wash, turn on the machine by pulling out the programming knob or (if
present on the washing machine) by pressing the On/Off pushbutton (the indicator
light will turn on).
At the end of the washing cycle, the washing machine will stop at one of the
STOP points on the programming knob.
1 Turn off the washing machine by pushing the programming knob in or (if present on
the washing machine) by pressing the On/Off pushbutton.
2 Take out the laundry
3 With dry hands, unplug the machine
4 Close the water tap.
8
To Next Page
Loading...
