Ardo DWI60 - Operating the Dishwasher; Turning the Dishwasher ON; Programme End Notification; Turning the Dishwasher OFF

18
Switching the dishwasher ON
Turn on the tap.
Open the door.
Press programme button “B” , programme indicator “A”
lights.
Set ON-OFF button “D” to ON, the ON-OFF indicator
"C" lights.
Close the door, the programme indicator “A” becomes to
blink and the programme starts automatically.
Interrupting the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
C
D
A
B
en
End of programme
Six beeps will indicate that the wash cycle has nished and all the indicators go out except the ON-
OFF indicator.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Open the door.
Set ON-OFF button “D ” to OFF.
Remove dishes, etc. when they have cooled down.