4
Cold water connection
Connect the water supply hose to a standard threaded water
outlet connector, making sure that it is fastened tightly in place
(see g.1).
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear and free of impurities. If this precaution is
not taken, there is a risk that the water inlet can get blocked
and damage the appliance.
Positioning the appliance
Positioning the appliance in the desired location. The back should rest against the wall behind it, and the
sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses
that can be positioned to the right or the left to facilitate proper installation.
g.1
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing
them in or out) to adjust the dishwasher, making it level. In any
case, the appliance should not be inclined more than 2˚. If the
appliance is level, it will help ensure proper performance.
Installation
Warning
The appliance is to be connected to the water mains using new
hose-sets and that old hose-sets should not be reused.
en
NOTE:
The minimum water pressure is 0.03 Megapascals.
The maximum water pressure is1.0 Megapascals.
To Next Page
Loading...