Name: Arduino MKR1000
Brand: Arduino
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Select your board type and port

You'll need to select the entry in the Tools > Board menu that corresponds to your Arduino or Genuino board.

Select the serial device of the board from the Tools | Serial Port menu. This is likely to be COM3 or higher

(COM1 and COM2 are usually reserved for hardware serial ports). To ﬁnd out, you can disconnect your board

and re-open the menu; the entry that disappears should be the Arduino or Genuino board. Reconnect the

board and select that serial port.

Questions and Answers:

Need help?

Do you have a question about the Arduino MKR1000 and is the answer not in the manual?

Arduino MKR1000 Specifications

General

Microcontroller	SAMD21 Cortex-M0+ 32bit low power ARM MCU
Operating Voltage	3.3V
Digital I/O Pins	8
PWM Pins	12
Analog Input Pins	7
Flash Memory	256 KB
SRAM	32 KB
Clock Speed	48 MHz
DC Current per I/O Pin	7 mA
Input Voltage (VIN)	5V
PCB Dimensions	61.5 mm x 25 mm
WiFi Module	WINC1500
Secure Element	ATECC508
UART	1
SPI	1
I2C	1
LED_BUILTIN	6
Length	61.5 mm
Width	25 mm
Weight	32 g
Analog Output Pins	1
WiFi	IEEE 802.11 b/g/n 2.4 GHz
Crypto Authentication	Yes