AREBOS AR-HE-BRT52ET - User Manual

Questions and Answers

V
Vincent MillerAug 10, 2025
How to fix an AREBOS AR-HE-BRT52ET Brush Cutter that does not start?
- M
  Michael KellyAug 10, 2025
  If your AREBOS Brush Cutter doesn't start, several factors could be the cause. It might be due to a dirty air filter (clean or replace it), a blocked fuel filter (clean or replace it), or a lack of fuel (fill it up). Other potential issues include a fuel line fault (check for kinks or damage), a defective starting device (check the launch device), or a sunken engine (remove, clean, and dry the spark plug; then pull the starter cable several times before reinstalling the spark plug). Also, check the spark plug connector for correct seating, clean or replace the spark plug if there's no ignition spark, or check the engine or carburetor for defects.
S
Shannon AguilarAug 14, 2025
Why my AREBOS AR-HE-BRT52ET does not operate at full power?
- K
  Kyle LeeAug 15, 2025
  If your AREBOS Brush Cutter isn't operating at full power, it could be due to several reasons. The machine might be overloaded, so avoid pressing with force during mowing or trimming. A dirty air filter can also cause this issue, so clean or replace it. Additionally, an incorrectly set carburetor can be the problem, so check the idle speed. Finally, a clogged silencer could be restricting power, so inspect the exhaust.
C
christine47Aug 19, 2025
What to do if my AREBOS AR-HE-BRT52ET stutters?
- D
  Dominic AdamsAug 19, 2025
  If your AREBOS Brush Cutter stutters or works with interruptions, it could be due to an incorrectly set carburetor (check the idle speed), a sooty spark plug (clean or replace the spark plug). If these steps don't resolve the issue, the on/off switch might be defective.
M
Ms. Dawn ThomasAug 25, 2025
Why is my AREBOS AR-HE-BRT52ET Brush Cutter smoking?
- A
  Adam HunterAug 25, 2025
  If your AREBOS Brush Cutter is emitting smoke, it could be due to an incorrect fuel mixture. Use a two-stroke mixture with a 40:1 power ratio. Another potential cause is an incorrectly set carburetor; in this case, check the idle speed.
P
Pamela StricklandAug 29, 2025
What to do if AREBOS AR-HE-BRT52ET motor starts but cutting tool is stationary?
- J
  Jonathan BaileyAug 30, 2025
  If the motor of your AREBOS Brush Cutter starts but the cutting tool remains stationary, it could be due to a blocked cutting tool (switch off the motor and remove the object). Alternatively, there might be an internal error (check the drive shaft and gearbox) or a defective coupling (check the coupling).
D
dawsonmatthewSep 4, 2025
What to do if the cutting thread is not guided to on my AREBOS AR-HE-BRT52ET Brush Cutter?
- T
  Tiffany MyersSep 4, 2025
  If the cutting thread of your AREBOS Brush Cutter is not guided, it is likely that the thread bobbin is empty. In this case, you should replace the thread bobbin.