What to do if my AREBOS AR-HE-SP600S motor will not run?
If your AREBOS Water Pump motor won't run, first ensure all electrical switches are on and the circuit breakers are properly set. Also, check the timer setting and the motor wiring at the terminals. Another possible cause is a jammed pump. If the power is off, try turning the pump shaft to see if it spins freely.
Why is the flow low in my AREBOS AR-HE-SP600S?
If your AREBOS Water Pump is experiencing low flow, it could be due to a dirty filter. Try backwashing or cleaning the cartridge. Also, check for dirty skimmer and pump strainer, and clean them if necessary. A suction air leak or closed valve/blocked line can also cause low flow; refer to solution 1 for guidance on these issues.
Why does my AREBOS AR-HE-SP600S motor run hot?
If your AREBOS Water Pump motor runs hot, an electrician should check the supply to ensure correct voltage. Motors running hot to the touch is normal. The thermal overload protector will turn the motor off if there's an overload or excessive temperature. Also, shield the pump from direct sunlight and ensure proper ventilation by not tightly covering or enclosing the motor.
Why is my AREBOS AR-HE-SP600S Water Pump operation noisy?
If your AREBOS Water Pump is making unusual noises, it could be due to several reasons. A bad bearing may require replacement by an electrician. An air leak in the suction line could be the cause. Check for and clean any suction blockages. If the noise is due to a disturbance in the impeller, contact the supplier. Cavitation can also cause noise; try improving suction, reducing suction lift, reducing the number of fittings, increasing pipe size, increasing discharge pressure, and reducing flow by throttling the discharge valve.
What causes my AREBOS AR-HE-SP600S motor overload to cut out?
If the motor overload in your AREBOS Water Pump keeps cutting out, have an electrician check the wiring to ensure the motor is connected properly. Also, the voltage at the motors should be no more than 6% above or below the nameplate voltage; have an electrician check this and ensure the pump is not running on an extension cord. Report any low supply to the authorities. Overload can also occur due to binding in the pump or the wrong size impeller; contact the supplier in this case.
What to do if AREBOS Water Pump is leaking?
If your AREBOS Water Pump is leaking, it could be a leak between the pump housing and pump cover, in which case you should change the O-ring between them. Alternatively, it could be a leak between the pump and motor, requiring a new pair of mechanical seals.
General| Brand | AREBOS |
|---|---|
| Model | AR-HE-SP600S |
| Category | Water Pump |
| Language | English |
To Next Page
