3/8” DRIVE DAMAGED
BOLT AND STUD EXTRACTOR TOOL
OPERATOR’S MANUAL
STORE THIS MANUAL IN A SAFE
PLACE FOR FUTURE REFERENCE
70016
(800) 340-1442
www.arestool.com
customerservice@arestool.com
Don’t forget to register your product
You are backed by the ARES Tool Performance Assurance!
ARES TOOL warrants this product to be free from defects in materials
and workmanship under normal use and service. A defective product
may be returned for a free replacement within 90 days from the date of
purchase, provide that product is returned immediately after discovery
of defect. This warranty shall be valid only when proof of purchase
(receipt) showing the date of purchase accompanies the defective
product.
Exclusions:
These warranties exclude blades, bits, punches, dies, bulbs, fuses,
batteries, and other consumables which must be replaced under normal
use and service. These warranties shall not apply to any product or
part which is used for a purpose for which it is not designed, or which
has been repaired or altered in any way so as to affect adversely its
performance or reliability, nor shall these warranties apply to any
product or part which is subject to misuse, neglect, accident, or
wear/tear incident to normal use and service
NEED HELP?
Universal Design allows
for removal of 1/4” to 1/2”
studs (6-12mm)
Hexagonal ats for use with
at wrenches, pliers,
adjustable wrenches,
sockets and locking pliers
3/8” drive useable with
hand ratchets,
impact tools and air ratchets
To Next Page
Need help?
General