9.3 Automatic display switch-off
Indicated by the symbol 0F, allowed values: 0-15.
The values set correspond to the minutes.
If the set value is 0, this function is not activated.
If the imported value is a value between 1 and 15, the display will automatically turn
off after a few minutes.
9.4 Wheel diameter
Indicated by the HD symbol, allowed values: 6-34.
The values set correspond to the inches of the wheel diameter. For your model,
leave the value at 28 otherwise the values shown on the display when using your
bike will not be correct.
9.5 Password - Speed limit
Indicated by the symbol Pd.
Then enter the password "1919" using the + and - buttons, confirm each single
value in the password entered with the M button.
After entering the password correctly, you enter the speed limit parameter indicated
by the SL symbol, allowed values: 10-100.
9.6 Motor parameter
Indicated by the HL symbol, make sure that the value set is number 1.
If a different value is set, anomalies in the speed detected on the display could
occur.
The maximum speed allowed by law is 25km / h.
Any interventions not authorized by the manufacturer to the control unit
exclude the manufacturer of any damage caused to people and / or things,
also the warranty on the purchased product is invalidated.
The control unit has been programmed not to allow changes to the maximum
speed parameter.
Maintain a speed and behavior appropriate to your abilities, never use the
bike above 25Km / h as it could cause serious damage and injury to yourself
or other people.
9.7 Number of assistance levels (PAS)
Indicated by the PA symbol, press the + and - buttons to switch between the
selectable values UBE - 3 - 5 - 9.
Do not select the UBE value (manufacturer's test value) in order not to find
anomalies on your display and compromise the normal operation of your electric
bike.
To Next Page
Loading...