14
APP DOWNLOAD AND SETTING UP APOLLO IN Wi-Fi MODE
a. Turn on the remote control
b. Set the dehumidification mode with the MODE key
c. Set the temperature to 20° C with the + and - keys
d. Set the timer (HOUR OFF) to 20 in the following way:
• Press the TIME key once to set 20 (HOUR OFF will flash during
the setting)
• Press the + key until you reach 20 (HOUR OFF will flash during
the setting)
• Press the TIME button again to save the setting (HOUR OFF fixed)
e. Press the LIGHT button for 5 consecutive times (light bulb symbol)
ATTENTION: the symbol of the light bulb must appear on the remote control and the LEDs of the unit Apollo
must be visible
f. At this point the Wi-Fi light on Apollo starts flashing (see the figure)
Wi-Fi light
EN
MINIMUM REQUIREMENTS FOR SMARTPHONE AND TABLET
With TuyaSmart App it is possible to manage the main functions of your air conditioner via smartphone and tablet.
To download and install the App, make sure that your device (smartphone or tablet) has a minimum standard version
of the operating system: version 4.4 or higher for Android, version iOS 9.0 or higher for Apple.
For Apollo connection to Tuyasmart App and use of Apollo via Tuyasmart App, see section at the end of this manual
(Wi-Fi GUIDE).
NOTE
1. Install the TuyaSmart App on your smartphone or tablet by framing the following QR code using a QR code reader
(Alternatively, search and install the TuyaSmart App in the App store of your smartphone or tablet):
2. Open the TuyaSmart App.
3. If you don’t have an account yet, create one.
4. Accedere all’app con le credenziali del proprio account.
5. Setting up Apollo in Wi-Fi mode:
To Next Page
Loading...
Need help?
General
