(G) Confirm and change the indoor unit address
The purpose of the above function is to let you confirm the indoor unit address after the auto. address
operation, and change the indoor unit address if it is needed.
a) Press the TEST / CHK and
# ( ¿ ) buttons at the same time for more than 4 seconds.
b) Select the R.C. No. which you want to change with the UNIT (up) or FLAP (down) buttons.
c) Press the SET button (to confirm the R.C. No.). The smallest registered indoor No. and the selected R.C.
No. will be displayed.
Ex:
R.C. No. 3 is selected.
Indoor No. 2 is the smallest indoor No. of
the R.C. No. 3.
d) Select the indoor No. which you want to change with UNIT button. Once in this mode, the fan motor of
selected indoor unit will turn on and let you confirm the indoor unit address.
I
SET CL
MODE
UNIT
FLAP
AIR FLOW
R.C.
SET CL
MODE
UNIT
FLAP
AIR FLOW
R.C. No.
0363
To Next Page
Loading...
Need help?
General
