(J) Change the period of the filter timer
If the period of filter timer is not suitable (for example in case of dirty environment), the period can be shortened
to half as follows:
a) Press the TEST / CHK button for more than 4 seconds.
b) In case of group control, if you want to change all units in group control collectively, proceed next step
remaining “ALL” displayed.
If you want to change a unit individually, select the indoor unit address (UNIT No.) with UNIT button.
c) Select the CODE No. 02 with
# , $ (SET TEMP) button.
d) Change the No. from 0 to 1 with
# , $ ( ¿ ) button.
EX:
UNIT No. 1–6
CODE No. 02
T type 150 hr 75 hr
e) Press the SET button.
CODE No. 06, SET DATA and change from flashing to ON state.
f) If you made a mistake, press the CL button.
g) Finally, press the TEST / CHK button.
SET CL
MODE
UNIT
FLAP
AIR FLOW
R.C. No.
0213_M_I
SET CL
MODE
UNIT
FLAP
AIR FLOW
R.C. No.
0214_M_I
56
To Next Page
Loading...
Need help?
General
