EasyManua.ls Logo

Argo Frontier 600 6x6 - User Manual

Argo Frontier 600 6x6
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATOR’S
MANUAL
MANUAL NO. 100-0103
Printed in Canada
08/2020
Do not remove this
manual from this vehicle.
Frontier 650 8x8
Frontier 700 8x8
Frontier 700 Scout 8x8
Frontier 600 6x6
Frontier 700 6x6
Frontier 700 Scout 6x6
Frontier 650 8x8 iFrontier 600 6x6 i

Table of Contents

Questions and Answers

  • K
    Kathleen NguyenAug 7, 2025
    What to do if my Argo Frontier 600 6x6 Offroad Vehicle engine turns over but will not start?
    • R
      Renee MunozAug 7, 2025
      If your Argo Offroad Vehicle's engine turns over but doesn't start, there are several potential causes: * The fuel tank might be empty: Refill the tank. * The fuel or air filter could be blocked: Remove the obstruction or replace the filter. * The spark plugs may be defective or fouled: Clean, re-gap, or replace them. * There may be insufficient compression: Take the vehicle to a factory authorized engine repair outlet. * The ignition system might be inoperative: Have the unit serviced by a properly trained and equipped mechanic.
  • J
    Joshua JonesAug 12, 2025
    Why is my Argo Frontier 600 6x6 electric starter inoperative?
    • K
      Kathryn AlvarezAug 12, 2025
      If the electric starter on your Argo Offroad Vehicle isn't working, it could be due to a few reasons: * Loose electrical connections: Clean and re-tighten them. * Low or dead battery: Recharge or replace the battery as needed. * Faulty starter motor: Return the vehicle to an Argo dealer for servicing.
  • R
    Roger SmithAug 17, 2025
    What to do if my Argo Frontier 600 6x6 Offroad Vehicle will not move or turn?
    • K
      Kyle PowersAug 17, 2025
      If your Argo Offroad Vehicle isn't moving or turning, consider these potential issues: * Transmission not properly engaged: Place the gear shift properly in gear. * Worn drive belt: Replace the belt if excessively worn. * Brakes not functioning: Adjust the caliper or replace brake pads. * Idler chain broken: Repair or replace it. * Idler sprocket weld broken: Have the vehicle serviced by an Argo dealer. * Clutch not engaging: Return the vehicle to an Argo dealer for servicing. * Transmission failure: Return the vehicle to an Argo dealer for servicing.
  • P
    Patrick PierceAug 22, 2025
    Why does my Argo Offroad Vehicle pull to the right?
    • S
      Sarah HansenAug 23, 2025
      If your Argo Offroad Vehicle is pulling to the right, check the following: * Right tire pressure: Inflate all tires to the correct pressure; the left tire might be too high. * Right brake: Make sure the handlebar is held parallel to the dash. Adjust the brake assembly if required. * Right side drive chain: Repair or replace if broken.
  • B
    brittanygreenAug 28, 2025
    What causes severe vibration in my Argo Frontier 600 6x6 Offroad Vehicle?
    • M
      Matthew AlvarezAug 28, 2025
      Severe vibration in your Argo Offroad Vehicle can stem from: * Engine loose on mounts: Take the vehicle to an Argo dealer for service. * Defective clutch or engine: Take the vehicle to an Argo dealer for service. * Bent axle: Remove and straighten or replace it. * Bent wheel rim: Replace it. * Worn or damaged drive belt: Replace it; clutch service may also be required.
  • J
    Jeremy NixonSep 2, 2025
    How to fix handbrake failure in Argo Frontier 600 6x6?
    • J
      jenniferrodriguezSep 2, 2025
      For handbrake failure in your Argo Offroad Vehicle: * If the brake pads are worn or the brake cable needs adjustment: Change the pads or adjust the brake cable. * If the brake pads are worn: Change the pads. * If there's a leaking caliper, brake lines, or air in the system: Take the vehicle to an Argo dealer for servicing.

Summary

SECTION 1 GENERAL INFORMATION

1.7 FRONTIER VEHICLE MATRIX

Specifications and features for Frontier 6x6, 8x8, and 6x6 i models.

SECTION 2 GENERAL OPERATING INFORMATION

2.1 NEW VEHICLE BREAK-IN PROCEDURE

Guidelines for breaking in a new Argo vehicle for optimal performance.

2.2 PRE-OPERATION CHECKS

Essential checks to perform before operating the vehicle.

2.5 FUELING THE VEHICLE

Safe procedures for refueling the Argo vehicle with gasoline.

SECTION 3 OPERATING INSTRUCTIONS

3.1 BRAKES AND STEERING

How to use the skid-steer system and brakes for control.

3.4 STARTING PROCEDURE

Step-by-step guide for starting the Argo engine.

SECTION 4 DRIVING PROCEDURES

4.3 TURNING THE VEHICLE

How to execute turns using the skid-steer mechanism.

SECTION 5 DRIVING PROCEDURES IN UNUSUAL CONDITIONS

5.3 UPHILL OPERATION

Techniques and warnings for driving up hills.

5.4 DOWNHILL OPERATION

Techniques and warnings for driving down hills.

5.5 SIDE SLOPE OPERATION

Risks and precautions associated with driving on side slopes.

5.6 AMPHIBIOUS OPERATION

Procedures for operating the Argo in water, including safety precautions.

SECTION 6 OIL, FILTER AND LUBRICATION INFORMATION

6.1 ENGINE OIL INFORMATION

Checking, selecting, and changing engine oil for optimal performance.

6.2 TRANSMISSION OIL INFORMATION

Checking and changing transmission oil levels and type.

6.4 LUBRICATION INFORMATION

Scheduled lubrication for various components like chains and bearings.

SECTION 7 MAINTENANCE INFORMATION

7.2 DRIVE SYSTEM & TIRES

Maintenance of drive belts, clutches, chains, and tire inflation.

7.3 HYDRAULIC BRAKES

Inspection, adjustment, and maintenance of the hydraulic brake system.

7.5 SERVICE CHARTS

Scheduled maintenance checks at 20 and 100-hour intervals.

7.6 MAINTENANCE SCHEDULE

Comprehensive schedule for regular vehicle maintenance tasks.

SECTION 11 ACCESSORY INFORMATION

11.7 POWER WINCH

Operation, safety rules, and maintenance tips for the power winch.

Argo Frontier 600 6x6 Specifications

General IconGeneral
BrandArgo
ModelFrontier 600 6x6
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals