14
V 06/17
HOW TO USE THE FAN HEATER
Set up the fan heater in a vertical position on a level and stable surface.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
Use the handle to move it.
On/off button (on the back, underneath the air intake grille).
Put the on/off button in the “I” position. When the appliance sounds a beep, this means that the fan heater is ready for use.
Put the button in the “0” position to switch off the fan heater.
TIMER ON/OFF
With this product it is possible to postpone both the TIMER ON and TIMER OFF.
TIMER ON
When the fan heater is in standby mode press the TEMPERATURE and TIMER button to set TIMER ON from 1 to 24
hours.
TIMER OFF
When the fan heater is working, press the TEMPERATURE and TIMER button to set the TIMER OFF from 1 to 24 ore.
LED DISPLAY AND CONTROL PANEL
Your settings will be stored even after switching off the appliance and after a power cut.
The appliance is equipped with an anti-tipping device which interrupts operations when the product is tilted.
Do not position the appliance on its side or upside down.
SWING button to turn on
automatic swin
.
ON/OFF button
ECO SMART mode – energy saving:
The default temperature is 22° C.
Below 18° C, the appliance runs at
high power. Between 18° C and 22°
C, the appliance runs at low power.
After 22° C, the appliance goes into
standby mode.
TEMPERATURE and TIMER
button
Press once to set the on or off
delay from 1 to 24 hours.
Press twice to set the desired
temperature (5-35° C).
Press a third time, or wait a few
seconds, to display the room
temperature.
+ and – buttons to
adjust the temperature
and running time of the
appliance
ON/OFF LED
POWER switch
button
Low power 1300W
High power 2000W
High power LED
To Next Page
Loading...
Need help?
General
Weight and Dimensions
