51
Warning: Use a Screwdriver
to position the Runners as
they could have sharp edges
Slide both of the Runners forward and locate the Drawer Sides between them, lining up the
holes in the Drawer Sides with the 2nd 'threaded' holes in the Runners.
Working from the inside of the Drawer, insert 2 Screws through the Drawer Sides and out into
the 2nd threaded hole in the Runner.
Note: Do not overtighten the Screws.
If they catch on the runner you may need to loosen them slightly.
N
x 4
www.youtube.com/watch?v=yG4xtiJJeSg
Fitting Ball Bearing Runners
Assembly is complete
Please remove any blue protective film from panel
edges and clear protective film from panel surfaces
ALR3717
To Previous Page
Loading...
