Argos Value PDI13YE3 - Troubleshooting; Plug Replacement

HELPLINE NO 08448012949
9
ORIGINAL INSTRUCTIONS
TROUBLESHOOTING
1. If your drill will not operate, check the power at
the mains plug.
2. If the drill is not cutting properly, check the
drill bit for sharpness, replace drill bit if worn.
Check that the drill is set to forward rotation for
normal use.
3. If a fault can not be rectied return the drill to
an authorized dealer for repair.
PLUG REPLACEMENT
Your Power Tool is supplied with a tted plug,
however if you need to t a new plug follow
the instruction below.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Blue = Neutral Brown = Live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with N.
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L .
If a 13 AMP (BS 1363/A) Plug is used, a 13 AMP
Fuse must be tted, or if any other type of plug is
used a 13 AMP Fuse must be tted, either in the
Plug or Adaptor, or on the Distribution Board.
NOTE: If a moulded plug is tted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
If the supply cord is damaged it must be replaced
by a service agent or a similarly qualied person
in order to avoid hazard.