Please check you have all the fittings listed below
Components - Fittings
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Tools required
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
Drill
(for use with wall plug)
0102030405060708090 100 110 120 130 140 150
0123456
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
The screws length is measured from the head to the point (30mm screw shown).
3
Locking screw x 12 (5x24mm)
FK1011
12mm
Locking nut x 6 (12x10mm)
FK1010
15mm
Large locking nut x 6 (15x12mm)
FK1012
Screw x 22 (4x12.5mm)
FK1309
Fixing screw drawer x 12 (6.3x10mm)
FK1301
Screw x 12 (4x25mm)
FK1985
Screw x 19 (4x15mm)
FK1400
Nail x 48
FK1515
Confirmat screw x 10 (7x70mm)
FK1007
Drawer handle x 6
GR1855
L-Bracket x 1
FK1235
Locking screw x 8 (5x8.5mm)
FK1056
Screw x 42 (3x15mm)
FK1311
Nail holder x 1
FK1415
Hanger rail support x 4
FK1223
Screw x 6 (4x40mm)
FK1006
Plug, Nylon x 2
FK1800
Peg, brown x 2
FK1234
Drawer base support x 12
FK1250
Support pin x 2
FK1203
Corner connector, white x 3
FK1248
Expando housing x 8 (20x12mm)
FK1051
Double plug, Nylon x 2
FK1801
Wood dowel x 4 (5x30mm)
FK1410
XW
V
U
T
S
R
P
O
NM
Q
L
KJ
IHG
F
E
D
CB
A
Piercer
(small)
To Next Page
Loading...
