as possible.
Automatically enter energy saving status
If it is not operated in 60 seconds, the camera will automatically enter
energy saving status.
Software Installation
Insert installation CD into CD-ROM driver, and installation screen will appear
(as shown in figure below).
1. Install PhotoImpression; 2.. Install Driver; 3. Browse CD-ROM; 4. Exit
Prompt: PhotoImpression (See reference or other instructions for detail).
Select “Install Application” and follow promptings to install. After this
installation is completed, select “Install CD-ROM driver”. You may select
installation language as needed.
Note: In case of failure in automatic installation or if you want to share CD with
other computer, manual installation is required. See installation steps below:
1. Install installation CD into CD-ROM driver, and installation screen will
appear (as shown in figure below). Select “Install PhotoImpression”.
To Next Page
Loading...
