10. Installation screen will appear. Click “Install Driver” to install camera
driver:
11. After the installation of driver is completed, it will activate the computer.
Taking Photos
Before using your digital camera, please check if the battery is low. To
take photos, please follow the following steps:
1. Press Shutter button and then press Mode button to start the camera. In
about 3 second, LCD on the back of your camera will display and buzzer
will give off a “Beep”. This means startup is completed.
2. Find objects to take via Viewfinder.
3. Hold the camera steadily, and press Shutter button to take photos.
4. You will hear one beep, indicating your photo has been taken. You may
continue taking photos.
5. When the camera is full of photos, the display will read “000”. When you
press Shutter, it will give off continuous “Beep” prompting.
Prompt:
1. Hold camera steadily while taking photos.
2. Insufficient light may affect the quality of photos. (In case of failure in
To Next Page
Loading...
