Set up the Camera on the App
Please follow the steps below to do initial setup for the battery-powered cameras
via Reolink App.
Step 1. Power on the camera. Remember to turn on the power switch on the
camera before initial setup except for Argus 2 and Argus Pro. After a startup sound,
you will hear a repeated Ding sound or a voice prompt.
Note: The voice prompt you will hear may be "Welcome to Reolink, please install
Reolink app and scan the QR code on the camera" in multilingual versions, or
"please run Reolink app, add the camera and set it up".
Step 2. Tap the icon in the top right corner to start the initial setup.
To Next Page
Loading...