2.0 Documentation - Part Number Information
2.1 Introduction
Please read this manual thoroughly prior to equipment use in order to become familiar with the
unit’s numerous features and operating procedures. To obtain a maximum degree of safety, follow
the prescribed sequences as outlined.
This manual incorporates warnings and notes to the user. Points that are vital to the proper opera
-
tion or safety of the operator are indicated by the heading: WARNING. Points that are important to
the performance or ease of use of the equipment are covered by a notation that is underlined
.
2.2 ARGUS Numbering System
ARGUS technologies uses a eight digit drawing number system which is broken into three blocks.
The first three digits describe the category of the product; e.g. rectifier or fuse panel. The next three
digits indicate the sequence in which the product number was allocated in a particular category.
The last two digits indicate the type of drawing; i.e.:
05 - Schematic
06 - Outline Drawing
20 - Bill of Material
ARGUS Technologies uses a eight digit part numbering system for all components and
sub-assemblies. Each part has its unique number. Due to the quantity, numbering categories are
not listed in this manual.
ARGUS TECHNOLOGIES Document #010-002-C0 Rev. H Page 1
To Next Page
Loading...