Need help?Do you have a question about the Argus RST 48/30 and is the answer not in the manual?
General| Output Voltage | 48 VDC |
|---|---|
| Output Current | 30 A |
| Output Power | 1440 W |
| Input Frequency | 47-63 Hz |
| Protections | Overvoltage, Overtemperature, Short Circuit |
| Safety Standards | UL62368-1, IEC62368-1, EN62368-1 |
| EMC Standards | EN55032, EN61000-3-2, EN61000-3-3 |
Important safety and compliance information regarding RF energy.
Details Argus's two-year warranty terms and conditions.
Procedure for obtaining RMA and returning products for service.
Procedure for accurately setting the unit's current limit.
Steps to adjust the unit's output voltage in Float mode.
Steps to adjust the unit's output voltage in Equalize mode.
Adjusting slope for load sharing and parallel unit operation.
Procedure for setting the over voltage shutdown threshold.
Procedure for setting the under voltage alarm level.
Explains over/under voltage protection and rectifier fail detection.
Covers common operating conditions, symptoms, causes, and repair procedures.
To Next Page