SPECIFICATIONS FOR ARGUS TECHNOLOGIES’ SWITCHED MODE RECTIFIER MODEL RST 48/30
Output
Voltage: 42 to 62VDC (test)
50 to 60VDC (equalize)
48 to 57VDC (float)
Current: 30 Amps DC nominal
Power: 1698 Watts continuous
Regulation: +/-.02% Line and load (static)
1% deviation for 50 to 100% load step (dynamic)
Time Stability: .1% per year
Temp. Stability: 100ppm/degree C over the operating range
Response Time: 1ms to .1% of output for 50 to 100% load step
Noise: Less than 22dBrnc (Voice Band)
10mV rms to 10MHz (Wide Band)
EMI: The unit meets requirements of FCC Rules Part 15 Subpart J
Level A. The unit also meets Bell Canada’s design standard
DS-8465 (Electromagnetic Interference/Compatibility Requirements
and Test Methods for Telecommunications Systems and Equipment)
Section 4. as per Test Methods detailed in Section 6.
Breaker Rating: 60 Amp; 5,000 Amp interrupting capacity at 65VDC
In Accordance with FCC requirements, we provide the following statement as specified in the FCC guidelines for
conformance to Part 15 Subpart J, Level A:
WARNING
: This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause interference to radio communications. It has been
tested and found to comply with the limits for a Class A computing
device pursuant to Subpart J of Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference
when operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference in which
case the user at his own expense will be required to take whatever
measures may be required to correct the interference.:WARNING
ARGUS TECHNOLOGIES 010-006-B1 Rev B Page 1 of 2
To Next Page
Loading...